The error code 5200 in the Canon printer occurs mostly due to problems in the cartridge. If the printing results are coming only in black, even if it’s a colored document, the ink cartridge is about to empty. the low ink levels, faulty cartridge, empty cartridge and logic board issues show 5200 errors. the troubleshooting guide will show you fixing the code. until you fix this issue, the printer will show issues while printing.you may also get blank pages with this error.
Wireless LAN Setup:
- Turn on your Canon printer to start the wireless LAN setup.
- Then simply press the menu button and see Network settings where you need to tap on Wireless LAN settings and select the SSID Settings option.
- Select Access Point and choose the favored network name.
- Next, enter the WiFi security key and wait for the connected prompt.
- Now download canon ij setup from https //ij.start.cannon and install on your pc.
WPS Push Button:
Set up a successful network connection for the Canon ij printer, press the WiFi button on your printer, and go to the access point once the orange alarm light becomes steady. Within two minutes, push the WPS button on your wireless router. If you can see Connected Status, press OK to confirm.
Cause:-
The main cause of the error code 5200 in canon printer is the empty cartridge. It means when the ink cartridges get empty or about to end the ink, you’ll see the error as a notification.
How to Fix Canon Printer Error 5200?
Find out the useful solution below so that you can fix the Canon printer 5200 issue.
1 – Refill the ink tank
- Check the ink level in your canon printer model.
- If it’s about to empty, refill the ink tank.
- Power off the canon printer.
- Unplug the power cord.
- Wait for 30 seconds to 50 seconds and plug in back.
- Again, turn on the printer.
- Perform system cleaning as you refill the tank.
2- Install Repair Tools
The error may not go just after replacing or refilling the ink tank. Download repair tools and install them to fix Printer Error 5200.
3- Reset Your Canon Printer
Resetting the Canon printer may not be necessary if refilling the ink tank is sorted out. However, if the printer isn’t printing in good quality as previously did, then you’ve to reset it through the below steps;
- If your Canon printer model is turned on, turn it off.
- Now, press the Stop or reset button.
- Release the Stop or Reset button and hold power ON button.
- At the same moment, press the stop/reset button two times.
- Make sure you are still holding the power button while tapping the reset button.
- Now, leave the power button.
- Wait for a few moments until you see the idle message.
- After the message is on display, open the cover on the top to see the cartridges.
- Take out ink cartridges and Put on the cartridge holder cover.
- Turn off the Canon printer.
- Close the top cover and start the printer again.
- When the printer gets turned on, out cartridges back and see whether the Error Code 5200 has disappeared or not.
If the issue doesn’t get solved, your printer needs servicing. If you’re in a 1-year manufacturer’s warranty, it’s easy to fix the problem on Warranty service.
For More Information Visit us : https //ij.start.cannon and ij.start.cannon
